Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Light Assembly on the RAM 3500 [USA]

Model: RAM 3500 DS, MK 4, DJ - Years: 2009, 2010, 2011, 2012, 2013, 2014, 2015, 2016, 2017, 2018, 2019
Part: Tail light

See other generations:
Video tutorial

To remove the rear light assembly on the RAM 3500, follow these steps: First, disconnect the support cable for the rear cargo floor and use a screwdriver to remove the two screws located on the inner side of the light. Then, use tweezers to pull out the two rubber clips located just above and below the screws.

At this point, by pulling towards you, you can detach and remove the light assembly. On the back, there is an electrical connector that can be released by lifting the red locking tab. To reinstall the light, reverse the steps taken.


Updated on 14 May 2026 by ScegliAuto


Related tutorials

How to Replace the Rear Brake Rotor on a RAM 3500
RAM 3500 (2009-2019 / DS, MK 4, DJ) To replace the rear brake rotor on a Dodge RAM 3500, loosen the bolts securing the wheel corresponding to the brake you are replacing. Once the wheel…
Removing the Hub Assembly from a Dodge Ram 3500
Removing the Hub Assembly from a Dodge Ram 3500
RAM 3500 (2009-2019 / DS, MK 4, DJ) The video shows a simple trick for removing the hub assembly from a Dodge Ram 3500. First, lift the vehicle to remove the wheel and the hubcap. Remov…
How to Replace the Key Battery on a Ram 3500 [USA]
How to Replace the Key Battery on a Ram 3500 [USA]
RAM 3500 (2009-2019 / DS, MK 4, DJ) To replace the battery in the remote key for the Ram 3500, follow these steps. Take the remote and first extract the security key by pressing the rel…

How to Remove the Toll Tag Holder from the Car Windscreen

The toll tag holder is usually attached to the car windscreen to ensure that the toll tag functions immediately when passing through barriers. However, if you decide to remove the holder, you should follow this procedure: - Insert the toll tag into the holder; - Pull the holder inwards to detach it from the windscreen; you can use a glass scraper or a stiff plastic card to assist you; After removing the holder, it is essential to remove the adhesive from the windscreen. To remove the adhesive, we recommend using a solvent-based spray that will remove the glue without clouding the area.

Watch the video!


by ScegliAuto

More videos