Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to change the coolant on the Dodge Ram 2500?

Model: RAM 2500 D2, MK 4, DS, DJ - Years 2009-2019
Part: Antifreeze coolant

In order to replace the coolant of the Dodge Ram 2500 you need to open the drain plug of the tank that contains it, loosening the fixing bolt. This drain plug is located in the lower part of the car, in correspondence with the engine compartment. By placing a container under the drain plug, the old liquid can be collected by closing the plug. Subsequently, by accessing from the engine compartment, it will be possible to top up from the special top cap: once the liquid has been inserted, it will be possible to close the cap and check that the car is working correctly.

Posted on 9 September 2022 by ScegliAuto

Video tutorial

Related tutorials

How to replace the fuel pump of the Dodge RAM 2500.
How to replace the fuel pump of the Dodge RAM 2500.
RAM 2500 (2002-2009 / DM, DH, D1, DC, MK 3, DR) Today's procedure will illustrate how to disassemble and replace the fuel pump of the Dodge RAM 2500, following the instructions below. First, we lif…
How to reset the oil warning light on the Dodge RAM 2500
RAM 2500 (2009-2019 / D2, MK 4, DS, DJ) If you have just changed the oil on your 2015 Dodge RAM and the warning light continues to come on, you must necessarily perform a manual reset to pe…
How to reset the oil warning light on Dodge Ram 2500
How to reset the oil warning light on Dodge Ram 2500
RAM 2500 (2009-2019 / D2, MK 4, DS, DJ) In this video tutorial it is possible to reset the oil warning light on Dodge Ram 2500, following a few simple steps that will guide you towards prop…

How to Remove the Steering Wheel Airbag on a Fiat Panda

How to remove the steering wheel airbag on a Fiat Panda? Before removing the car's steering wheel, disconnect the battery terminals located in the engine bay. Here's how to proceed with the removal: remove the inspection caps at the back of the steering wheel (if present), then unscrew the screws/fasteners of the steering wheel cover (where the airbag is located) using a socket wrench or screwdriver. Once the airbag is released (driver's side), disconnect the power connectors and remove it from the steering wheel. For reassembly of the airbag: connect the power connectors and fit the airbag with the screws.

Watch the video!


by ScegliAuto

More videos