Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Fuel Filter on a Ram 2500 [USA]

Model: RAM 2500 DT, MK 5 - Years: 2019, 2020, 2021, 2022, 2023, 2024, 2025, 2026
Part: Diesel fuel filter

See other generations:
Video tutorial

To replace the fuel filter on this model, follow these steps. Open the hood and lift the vehicle.

Above the driveshaft, at the rear center, you will find the filter. Get a container to catch the fuel and place it on the ground.

Unscrew the drain plug located on the side of the filter cover and drain the fuel. Next, using a socket wrench, unscrew the filter cap, being careful as more fuel will come out. At this point, remove the filter and take the new filter suitable for the vehicle (refer to the owner's manual).

Replace the o-ring on the filter cap threads and lubricate it. Insert the new filter into the housing in the correct orientation and push it in fully, then screw the cap back on and tighten it with the socket wrench.


Updated on 19 June 2026 by ScegliAuto


Related tutorials

How to Replace the Fuel Filter on a RAM 2500 6.7L
How to Replace the Fuel Filter on a RAM 2500 6.7L
RAM 2500 (2009-2019 / MK 4, DJ, DS, D2) In today's tutorial video, we will see how to disassemble and replace the fuel filter on a fourth-generation RAM 2500 with a 6.7L engine. First, lift…
How to Replace the Fuel Pump on the Dodge RAM 2500
How to Replace the Fuel Pump on the Dodge RAM 2500
RAM 2500 (2002-2009 / D1, MK 3, DR, DH, DC, DM) Today's procedure will show you how to remove and replace the fuel pump on the Dodge RAM 2500, following the instructions below. First, lift the vehi…
How to Replace the Rear Diesel Fuel Filter in a RAM 2500
How to Replace the Rear Diesel Fuel Filter in a RAM 2500
RAM 2500 (2009-2019 / MK 4, DJ, DS, D2) In today's tutorial video, see how to remove and replace the rear diesel fuel filter in a RAM 2500 by following these simple and quick steps. First, …

How to Reset the Tyre Light on a Toyota Aygo?

To reset the tyre light on a Toyota Aygo, start by locating the reset button, which is found in the glove compartment of the front passenger side. Turn on the car and ensure that the tyres are at the correct pressure. Then, press and hold the reset button for a few seconds until the tyre light either flashes or turns off, depending on the model. Release the button and wait for the reset procedure to complete. Restart your Toyota Aygo and check if the tyre light has turned off, indicating that the reset was successful.

Watch the video!


by ScegliAuto

More videos