Do it yourself
Frequently asked questions about cars and motorcycles

How to replace a Dayco accessory belt on a Renault Clio IV 1.5 dCi.

Model: Renault Clio Clio IV, MK 4, Clio 4 - Years 2012-2019
Part: V-belt

In this video, we will see how to change a Dayco service belt, which can be found complete with the pulley on eBay with the code 388758211880 for the price of 43.90 euros + 14.90 euros for shipping. It is essential to also have a torque wrench to tighten the tensioner pulleys to the correct torque. With the engine cold, disconnect the battery, lift the car and remove the lower engine protection. Take a photo of the belt immediately to remember how it is arranged, then identify the tensioner pulley, which is a pulley with a central hexagonal pin located between the alternator, the A/C compressor and the engine: insert the wrench and slowly rotate it clockwise. Some models have a hole to insert a locking pin once the tension is released. Remove the belt, clean the pulley grooves from any residue, and pass the new belt following the path from the photo we took earlier. Slowly release the tension on the tensioner, allowing the pulley to tension the belt; check that the belt is perfectly aligned, then reassemble everything and lower the car.

Posted on 27 August 2025 by ScegliAuto

Video tutorial

Related tutorials

Renault Clio (2012-2019 / Clio IV, MK 4, Clio 4) In order to replace the timing belt of the Renault Clio 1.5 DCi, you need to loosen the screws that secure the front right wheel of the car, so that …
Renault Clio (2005-2013 / MK 3, Clio 3, Clio III) In today's tutorial, you will see the main instructions on how to remove and replace the timing belt on a Renault Clio 1.5 DCi, as well as on other c…
Renault Clio (2005-2013 / MK 3, Clio 3, Clio III) Today, we will look at the instructions that will allow you to remove and replace the timing belt on the Renault Clio 1.5 DCI. First, raise the vehic…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos