|
Do it yourself
| |||
| ||||
How to replace the windshield washer pump on a Renault Clio III
Model: Renault Clio
MK 3, Clio 3, Clio III
- Years 2005-2013
Let's see how to change the windshield washer pump on the Renault Clio III: it is a common problem, the liquid comes out from the wheel arch instead of the nozzles on the hood, indicating a leak in a pipe or a malfunction of the pump. Access to the windshield washer components is done by removing the inner fender, composed of a front section and a rear section. The front section is fixed by 4 plastic clips and 2 bolts, which are located under the bumper and in the lower left part of the wheel arch. The rear section is fixed by 4 clips and 1 bolt. Here we must be very careful, because the brake line passes through this area; before completely removing the fender, make sure not to damage it. Check if the plastic tube is broken or disconnected, or if the pump is faulty. To repair the tube, simply cut the damaged part and insert a connector to join the two cut sections of the tube. If it is the pump that is not working, disconnect the electrical connectors and tubes to replace it. Reassemble the fender and adjust the nozzles, after filling the tank.
Posted on 2 November 2025 by ScegliAuto
Video tutorial
Related tutorials
Renault Clio
(2005-2013 /
MK 3, Clio 3, Clio III)
In this video we can see how to replace the windshield washer pump of a Renault Clio III; so we open the hood, and the pump is located near the winds…
Renault Clio
(1998-2005 /
Clio 2, MK 2)
In this guide, remove and replace the windscreen washer pump on a second series Renault Clio in simple steps. First, open the bonnet of your car and …
Renault Clio
(1998-2005 /
Clio 2, MK 2)
To replace the windscreen washer pump on a Renault Clio, you need to loosen the screws that secure the trim panel at the base of the windscreen. Befo…
Other guides you may be interested in
|
How to Repair the Key Spring of the Peugeot 207?
Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.068
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
