Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to change the front brake pads of the Renault Captur 1.

Model: Renault Captur MK 1 - Years 2013-2019
Part: Brake pads

In this video, we will see how to change the front brake pads of the Renault Captur 1: first, we open the brake fluid reservoir, then we lift the front of the car and remove the two front wheels. We insert a flat screwdriver into the outer edge of the brake caliper to retract the piston, then we loosen the screws of the upper and lower brackets. Using a zip tie, we secure the caliper to the suspension spring to prevent damage to the brake hose. We remove the anti-noise springs, then we clean the brake pad support with a wire brush. We install the new anti-noise springs; we apply copper grease to the outer part of the pads and place them in position, detach the caliper and put it back in place, reattaching the bracket screws and tightening them to 27Nm. We repeat on the other side, then we reassemble the wheels, lower the car, and close the brake fluid reservoir.

Posted on 5 January 2026 by ScegliAuto

Video tutorial

Related tutorials

How to replace the front brake pads of the Renault Captur.
How to replace the front brake pads of the Renault Captur.
Renault Captur (2013-2019 / MK 1) Let's see the instructions that will allow us to disassemble and replace the front brake pads of the Renault Captur. First, we lift the vehicle and s…
Replacing the Front Brake Discs and Pads on the Renault Captur
Replacing the Front Brake Discs and Pads on the Renault Captur
Renault Captur (2013-2019 / MK 1) Below are the instructions that will allow you to dismantle and replace the front brake discs and pads on the Renault Captur. First, lift the vehicle…
How to change the brake pads on the Renault Captur 1
How to change the brake pads on the Renault Captur 1
Renault Captur (2013-2019 / MK 1) Let's see how to change the brake pads on the Renault Captur 1: first, open the hood and unscrew the cap of the brake fluid reservoir; lift the car a…

Other guides you may be interested in

How to reset the tyre pressure warning light on the Suzuki Jimny?

To reset the tyre pressure warning light on the Suzuki Jimny, first inflate the tyres to the pressure value indicated on the corresponding sticker: this is located at the bottom of the driver's door pillar. Once the tyres are inflated, insert the ignition key and turn on the instrument panel: select the screen that indicates the tyre pressures, checking that the values change. After a few seconds, the tyre pressure warning light will automatically turn off.

Watch the video!


by ScegliAuto

More videos