Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Front Headlight of the Renault Clio 3?

Model: Renault Clio MK 3, Clio 3, Clio III - Years 2005-2013
Part: Headlight

To remove the front headlight of the Renault Clio, loosen two screws located at the bottom of the car. Another two screws must be removed from the lower part of the wheel arch; inside, you will also need to remove some rivets to take off the inner cover. This will allow you to access the bolts securing the bumper internally and disconnect the connectors that will now be accessible. By loosening the bolts located at the top of the bumper and near the headlight, you will be able to pull it out of its housing and disconnect its connector.

Updated on 24 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Front Headlight Bulb on a Renault Clio 4?
How to Replace the Front Headlight Bulb on a Renault Clio 4?
Renault Clio (2012-2019 / Clio IV, MK 4, Clio 4) To replace the front headlight bulb on a Renault Clio 4, open the bonnet to access the rear of the headlight corresponding to the bulb to be replaced…
How to Replace the Front Headlight Bulb of the Renault Clio
How to Replace the Front Headlight Bulb of the Renault Clio
Renault Clio (1998-2005 / Clio 2, MK 2) Let’s go through the steps to remove and replace the front headlight bulb of the Renault Clio, following these simple and quick steps. First, open th…
How to Remove the Rear Light on a Renault Clio 2?
How to Remove the Rear Light on a Renault Clio 2?
Renault Clio (1998-2005 / Clio 2, MK 2) To remove the rear light on a Renault Clio 2, open the boot lid: on the side wall of the boot, near the light to be removed, there will be a knob tha…

Other guides you may be interested in

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos