Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Renault
    3. :
  3. Clio
    4. : How to replace the license plate lights of the Renault Clio

Renault Clio - Video tutorial

Model: Renault Clio MK 3, Clio 3, Clio III - Years 2005-2013
Part: License plate light
Operation: How to replace the license plate lights of the Renault Clio

If one of the license plate lights of your Renault Clio Mk3 no longer works then you must necessarily proceed with its replacement so as not to have any problems with the law (as well as safety). Below we will find out how to do it. First of all turn off the car completely. Then go to the rear of the vehicle and, using a flathead screwdriver, remove the spotlight containing the bulb to be replaced. Disconnect the connector from the spotlight and proceed by opening it. Replace the existing bulb with a new one and close the headlight. At this point all that remains is to reconnect the electrical connector and put the spotlight back in its original position.


Posted on 30 April 2024 by ScegliAuto



How to change the license plate light bulbs on the Renault Clio IV.
Renault Clio (2012-2019 / Clio IV, Clio 4, MK 4) In this video, we see how to change the license plate light on a Renault Clio IV; we will replace the old yellow light bulbs with bright white LED bu
Clio license plate light replacement
Renault Clio (1998-2005 / Clio 2, MK 2) Let's see how to replace the bulb that illuminates the Renault Clio license plate. The spotlight of the license plate is placed in the rear bumper, l
Renault Clio 3 license plate light replacement
Renault Clio (2005-2013 / MK 3, Clio 3, Clio III) Let's see how to replace the license plate lights of a Renault Clio third series, following these simple instructions. First we are going to remove t

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos