|
Do it yourself
| |||
| ||||
How to Remove the Steering Knuckle on a Renault Clio 3
Model: Renault Clio
MK 3, Clio 3, Clio III
- Years 2005-2013
In this video tutorial, see how to remove the steering knuckle on a Renault Clio 3 by following some simple steps. First, get into the vehicle, turn off the engine, and pull the handbrake. Next, loosen the bolts on the front wheel without removing them completely; use a jack to lift the front of the vehicle and fully unscrew the bolts. The next step is to remove the front wheel to access the steering system; place axle stands under the vehicle for added safety. Once the front wheels are removed, place them under the vehicle. Now you can see the steering knuckle. Use some penetrating fluid as the knuckle may be stuck. Make a mark as you will need it when refitting. Use an adjustable spanner to loosen the retaining nut of the knuckle. Use a 17 mm socket to unscrew the retaining nut of the knuckle. Use a hammer to give a sharp tap on the nut you just positioned on top of the thread. Unscrew the knuckle, being careful of the mark you made earlier and counting the number of turns needed to remove it. Refit the new knuckle by reversing the process (see video).
Updated on 2 July 2026 by ScegliAuto
Video tutorial
Related tutorials
Renault Clio
(2012-2019 /
Clio IV, MK 4, Clio 4)
In order to replace the timing belt of the Renault Clio, you need to lift the car with a jack so that the front right wheel can be removed from its h…
Renault Clio
(2005-2013 /
MK 3, Clio 3, Clio III)
How to open the fuel filler flap on a Renault Clio? First, open the rear hatch and access the boot; detach the fabric or plastic trim with a suitable…
Renault Clio
(1998-2005 /
Clio 2, MK 2)
Today, you will learn how to replace the engine oil and oil filter on your Renault Clio. First, remove the oil filler cap to avoid creating a vacuum …
Other guides you may be interested in
|
How to Repair the Key Spring of the Peugeot 207?
Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.199
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |