Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Renault
    3. :
  3. Clio
    4. : How to remove the gear knob on the 2002 Renault Clio

Renault Clio - Video tutorial

Model: Renault Clio Clio 2, MK 2 - Years 1998-2005
Part: Gear Shift Knob
Operation: How to remove the gear knob on the 2002 Renault Clio

Hi, in this video we will see how to remove the gear knob of your Renault Clio. With the vehicle off, squeeze the clutch and then engage fourth gear for a firmer grip. Start moving the knob from right to left and try lightly to pull with little force. If the knob does not come out again, increase the force to be applied. When we see that the knob is able to move, let's do more strength. Once the knob is released, you have to pay attention to the gearbox spring. If it comes out, insert it again. Take the new knob and place it on the special hook. Give it a light tap and the job is done


Posted on 20 September 2023 by ScegliAuto



How to remove the gear knob of a Renault Clio
Renault Clio (1998-2005 / Clio 2, MK 2) Before starting, we will have to sit in the driver's seat of our Renault Clio. Let's start then by going to disengage and lift the lower section of t
How to change the gear knob of the Renault Clio 2
Renault Clio (1998-2005 / Clio 2, MK 2) Today we will see, in this video tutorial, how to remove and replace the gear knob of the Renault Clio second series, in simple steps. First we get o
Removal of gear knob on Renault Clio - Dacia Sandero
Renault Clio (2012-2019 / Clio IV, Clio 4, MK 4) In today's video we will see how to remove and replace the gear knob on a Renault Clio fourth series, but also on the Dacia Sandero or the Duster. Ch

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos