Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Renault
    3. :
  3. Master
    4. : How to replace the starter motor of the Renault Master 2.5

Renault Master - Video tutorial

Model: Renault Master MK 2 - Years 1997-2010
Part: Starter motor
Operation: How to replace the starter motor of the Renault Master 2.5

Today's guide will show us the main instructions on how to disassemble and replace the starter motor of the Renault Master 2.5. First of all, we open the hood and start locating the starter motor, located on the bottom part; it will be necessary to raise the vehicle in order to access it, unscrewing the fixing screws and disconnecting its electrical wiring in order to remove it, as shown in the video. At this point, we carry out the repair or install the new starter motor; we make the electrical connection and fix it properly!


Posted on 5 May 2024 by ScegliAuto



How do you replace the starter motor of the Renault Master?
Renault Master (1997-2010 / MK 2) In order to replace the starter motor of the Renault Master, you need to lift the car with a jack or a lift, so that the front wheels of the vehicle
How to replace the starter motor on Renault Master 3 12.3 DCI
Renault Master (2010-2023 / MK 3) In this video we will see the instructions that will allow us to disassemble and replace the starter motor on the Renault Master third series. First
How do you replace the starter motor of the Renault Master?
Renault Master (2010-2023 / MK 3) The procedure for replacing the starter motor of the Renault Master involves lifting the vehicle with a jack or a lift, so that the front wheels of t

Fiat Ducato 2.8 JTD gearbox oil replacement

Let's see in this guide the main steps to be able to change the transmission oil of the second series Fiat Ducato, with 2.8 JTD engine. First of all we lift the car and go to locate the gear oil vent bolt, which we find near the transmission; we use a hex wrench to unscrew it, letting it drain the old oil in a container for about ten minutes. At this point we open the bonnet and remove the air intake sleeve, so as to be able to access the gearbox oil filling hole; then we fill up to the maximum level!

Watch the video!


by ScegliAuto

More videos