Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Saab
    3. :
  3. 9 5
    4. : Injectors

Saab 9 5 - Injectors

Saab 9 5 (1997-2010 / MK 1, Ys3e)
How to remove the LPG injectors from the Saab 9-5.
Let's see in this guide the main steps that will allow us to disassemble and replace the LPG injectors of the Saab 9-5. First of all, we open the engine hood …read all…
Posted on 9 July 2023 by ScegliAuto
Saab 9 5 (1997-2010 / MK 1, Ys3e)
Direct ignition coil replacement
The direct ignition coil is a transformer that converts voltage. Every vehicle that is equipped with an internal combustion engine has one. In case of failure, …read all…
Posted on 23 July 2023 by ScegliAuto
Saab 9 5 (1997-2010 / MK 1, Ys3e)
Replacing the injection cassette
The following video tutorial demonstrates how to replace the ignition cassette on a Saab 9-5. The operation takes very little time. The injection cassette is …read all…
Posted on 5 July 2023 by ScegliAuto
Alternator (1) Air conditioning (1) Car stereo (2) Spark plugs (1) Key (1) Locking the trunk (1) Timing belt (1) Air conditioning controls (1) -board computer (1) Checks and maintenance (1) Headlight (1) Air filter (1) Cabin air filter (3) Petrol filter (1) Injectors (3) Accessory Kit (2) Third brake light (1) Engine (7) Window motor (2) Starter motor (1) Gear oil (2) Engine oil (2) Door panel (2) Windshield (1) Front bumper (1) Rear bumper (1) Brake pads (3) Gear Shift Knob (1) Fuel pump (1) Instrument cluster (2) Crankshaft RPM sensor (2) Engine head (1) Valve (1) Interior blower (1)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos