Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Removing Fog Light on Seat Ateca

Model: Seat Ateca MK 1 - Years: 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024, 2025
Part: Fog lights

Video tutorial

Learn how to remove the fog light on a Seat Ateca. Unscrew the securing screw of the plastic covering the fog light, then use a lever to remove it from the bumper.

Once the plastic is removed, unscrew the side screws of the fog light and pull it out from the car's bumper (disconnect the power cable). Fit the new part with a new bulb (if damaged), and screw the securing screws back on the sides of the fog light.

To complete the installation of the fog light, secure the protective plastic around the lamp by tightening the screws.


Updated on 10 April 2026 by ScegliAuto


Related tutorials

Removing the Rear Light of the Seat Ateca
Removing the Rear Light of the Seat Ateca
Seat Ateca (2016-2025 / MK 1) Today's steps will show you how to remove and replace the rear light and its bulbs on the Seat Ateca. First, open the boot lid and start by removing …
Where to Find the Fuses in the Seat Ateca
Where to Find the Fuses in the Seat Ateca
Seat Ateca (2016-2025 / MK 1) If you own a Seat Ateca and are wondering where the fuse box is located, read this guide to find it quickly and independently. First, reach the drive…
Where are the Fuses Located in the Seat Ateca?
Where are the Fuses Located in the Seat Ateca?
Seat Ateca (2016-2025 / MK 1) The fuses of the Seat Ateca are contained within the dedicated fuse boxes installed in the vehicle: in this type of vehicle, you can find two boxes f…

How to Reset the Tyre Pressure Warning Light on a Kia Rio?

The tyre pressure warning light displayed on the instrument cluster of the Kia Rio can be reset by inflating the tyres until they reach the recommended pressure value: this value is indicated on the sticker affixed to the driver's door pillar. Once all tyres have been inflated to the recommended pressure, turn on the ignition to check that the light has disappeared: if it is still present, it may be necessary to drive for a few miles, allowing the sensors to work and thus turning off the light.

Watch the video!


by ScegliAuto

More videos