|
Do it yourself
| |||
| ||||
How to Replace the Timing Chain on a Seat Ibiza 1.2 Petrol
Model: Seat Ibiza
6P, 6J
- Years 2008-2017
Open the bonnet and immediately disconnect the battery (always disconnect the negative terminal first). Unclip and remove the upper engine protection cover, then locate the timing belt cover on the left side of the engine block. There are clips on the sides of the cover that need to be opened to remove it. Loosen the auxiliary belt tensioner and remove the belt. Unscrew the securing bolts of the lower timing belt cover. Insert two pins into the two upper pulleys to prevent them from going out of phase. Remove the mounting nuts of the engine support and then remove the engine support plate from the block. Mark the position of a tooth on a lower pulley relative to a tooth on the belt with a marker, and do the same on the upper pulleys and both belts. Loosen the tensioner pulley bolt and remove the belt. Always mark the relative position of the belt to the pulley with a marker. Install the new belts and reverse all the reassembly operations.
Updated on 19 June 2026 by ScegliAuto
Video tutorial
Related tutorials
Seat Ibiza
(2002-2009 /
6L)
Start by unclipping and removing the upper engine cover of your Seat Ibiza. Once done, unclip and remove the cover for the auxiliary belt and timing …
Seat Ibiza
(2008-2017 /
6P, 6J)
Below are the steps to remove and replace the timing belt on the Seat Ibiza 1.0 MPI. First, lift the vehicle and start by removing the front right wh…
Seat Ibiza
(2008-2017 /
6P, 6J)
To replace the timing belt on the Seat Ibiza, start by raising the front right side of the car, removing the wheel, and taking off the inner wheel ar…
Other guides you may be interested in
|
Where is the Fuel Filter Located in a Volvo XC60?
In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.173
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |