Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Install the Car Radio on the Seat Ibiza

Model: Seat Ibiza 6P, 6J - Years 2008-2017
Part: Car stereo

Installing a new car radio in the Seat Ibiza is a very simple operation that you can carry out independently, thanks to this video tutorial. The first step is to remove the previous radio; use some plastic levers to remove the plastic trim. Using a Torx T20 key, unscrew the screws securing the radio and remove it from its housing. Disconnect the antenna cable and the power connector to which all the wires are connected, then remove the connector from the CAN BUS unit. Now, pass the USB input cables from under the dashboard and then connect the GPS. Screw in the screws for the new brackets and the plastic trim provided with the new radio. Connect the connector and the antenna, and you're done.

Updated on 20 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to remove the original stereo radio from a Seat Ibiza 6j
How to remove the original stereo radio from a Seat Ibiza 6j
Seat Ibiza (2008-2017 / 6P, 6J) In this video we see how to remove the original radio from a Seat Ibiza 6J: we will need a plastic spatula to remove the frame of the original radio …
Removing the Standard Radio from the Seat Ibiza
Removing the Standard Radio from the Seat Ibiza
Seat Ibiza (2008-2017 / 6P, 6J) Today's step-by-step instructions will show you how to remove and replace the standard radio in the Seat Ibiza. First, get inside the cabin and inser…
How to reset the radio in a Seat car?
How to reset the radio in a Seat car?
Seat Ibiza (2002-2009 / 6L) Thanks to the video guide here to support us, we can learn how to unlock the radio in a Seat vehicle, specifically the Seat Ibiza 6L. After turning o…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos