Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to disassemble the turn signal light of the Smart ForTwo 451

Model: Smart Smart 451 - Years: 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015

See other generations:
Video tutorial

The guide shows how to disassemble the turn signals of the Smart ForTwo 451. To perform the operation properly, it is advisable to use a plastic lever in order not to damage the bodywork; alternatively, with great care, a small flat-head screwdriver can be used.

With the plastic lever, pry on the curved part of the turn signal light.

Release the retaining pin on the other side of the component. At this point, it is possible to disconnect the electrical connector and replace the bulb or the light unit.


Posted on 18 December 2024 by ScegliAuto


Related tutorials

How do you replace the front headlight bulb in the Smart Fortwo 451?
How do you replace the front headlight bulb in the Smart Fortwo 451?
Smart (2007-2015 / 451) Replacing a headlight bulb on the Smart Fortwo 451 does not necessarily require going to a workshop, as it only takes a few minutes for the job to be…
How to Install the Clutch Actuator on the Smart Fortwo 451
How to Install the Clutch Actuator on the Smart Fortwo 451
Smart (2007-2015 / 451) In today's tutorial video, you will learn how to install the clutch actuator on the Smart Fortwo 451 by following the instructions below. First, lift…
How to Remove the Third Brake Light of a Smart ForTwo 451
How to Remove the Third Brake Light of a Smart ForTwo 451
Smart (2007-2015 / 451) Before you can start, exit the cabin of your Smart ForTwo 451 and head to the rear of the car. Begin by unscrewing and removing the screws securing t…

How to Remove the Toll Tag Holder from the Car Windscreen

The toll tag holder is usually attached to the car windscreen to ensure that the toll tag functions immediately when passing through barriers. However, if you decide to remove the holder, you should follow this procedure: - Insert the toll tag into the holder; - Pull the holder inwards to detach it from the windscreen; you can use a glass scraper or a stiff plastic card to assist you; After removing the holder, it is essential to remove the adhesive from the windscreen. To remove the adhesive, we recommend using a solvent-based spray that will remove the glue without clouding the area.

Watch the video!


by ScegliAuto

More videos