Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Guide to replacing the starter motor of the Smart Fortwo 0.8 CDI.

Model: Smart Smart 450 - Years 1998-2007
Part: Starter motor

In this video tutorial, we will see the main steps useful for disassembling and replacing the starter motor of the Smart Fortwo 0.8 CDI. First, we open the rear hatch to access the engine compartment; then we locate our starter motor, where it will be necessary to disconnect various pipes to access it, as shown in the video. At this point, we unscrew its fixing screws and disconnect the electrical wiring to remove it and replace it with the new original one (or repair it), following the video tutorial until the end!

Posted on 25 September 2023 by ScegliAuto

Video tutorial

Related tutorials

How to replace the transmission oil in the Smart Fortwo CDI.
How to replace the transmission oil in the Smart Fortwo CDI.
Smart (1998-2007 / 450) Shortly, we will see the steps necessary to replace the transmission oil of the Smart Fortwo CDI. It is possible to perform the oil change operation …
How to disassemble the turbocharger of the Smart Fortwo 0.8 CDI
How to disassemble the turbocharger of the Smart Fortwo 0.8 CDI
Smart (1998-2007 / 450) Today we will see the instructions that will allow us to disassemble and replace the turbocharger of the Smart Fortwo 0.8 CDI. First of all, lift the…
How to disassemble the turbocharger of the Smart Fortwo 0.8 CDI.
How to disassemble the turbocharger of the Smart Fortwo 0.8 CDI.
Smart (1998-2007 / 450) Let's see in this guide how to disassemble and replace the turbocharger of the Smart Fortwo 0.8 CDI. First, we open the rear hatch and start unscrewi…

Other guides you may be interested in

    Frequently Asked Questions

    • Smart 2014-2022 - Where is the starter motor located on my Smart 453? Read answer

How to Replace a Damaged Wheel on a Nissan Qashqai

Learn how to replace a damaged wheel on a Nissan Qashqai: open the boot and take the wheel removal kit which includes: jack, jack lever, screwdriver, wheel nut key (if present), telescopic wrench, spare wheel. Position the jack under the jacking point of the vehicle (under the stiffest part of the chassis), lift the car slightly and loosen the wheel nuts. Raise the car with the jack lever and unscrew the nuts, then remove the damaged wheel. Fit the spare wheel onto the hub with the respective nuts and lower the car to the ground. Always remember to store the removal kit back in the boot.

Watch the video!


by ScegliAuto

More videos