Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Instructions for Installing an Aftermarket Car Radio

Model: Subaru Impreza MK 2 - Years 2001-2007
Part: Car stereo

Installing an aftermarket car radio is quite straightforward, especially since you can purchase the wiring and fitting kit along with the radio; start by disconnecting the battery, then detach the central console trim that includes the air vents; unscrew the mounting screws of the radio, pull it out from its housing, and disconnect the connectors; prepare the fitting wiring, pass the microphone for the hands-free kit from behind the instrument cluster by first removing the trim, and complete the installation by inserting the fitting kit and the radio.

Updated on 16 February 2026 by ScegliAuto

Video tutorial

Related tutorials

Instructions for Replacing Half Shaft
Instructions for Replacing Half Shaft
Subaru Impreza (2011-2016 / MK 4) Loosen the wheel fixing bolts before lifting the vehicle, then position it on suitable axle stands and complete the wheel removal; straighten the ind…
Front Headlamp Bulb Replacement
Front Headlamp Bulb Replacement
Subaru Impreza (2011-2016 / MK 4) To access the bulbs of the left front headlamp, you must first remove the battery: ensure you have any necessary unlocking codes, such as for the rad…
Installing Upgraded Brake Discs
Installing Upgraded Brake Discs
Subaru Impreza (2001-2007 / MK 2) Lift the vehicle onto a ramp or suitable axle stands and remove the rear wheel. Use a C-clamp to retract the piston of the brake caliper to facilitat…

Other guides you may be interested in

How to Install Roof Bars on a Fiat 500L

Learn how to fit universal roof bars on a Fiat 500L. These bars are used on vehicles with or without roof rails. Assemble the roof bar kit (as shown in the video) with bars adjusted to the width of the vehicle (measure with a tape measure). Position the brackets at both ends of the doors on the vehicle's original roof rails. Once the anchoring bracket width is set, tighten the bolts with a butterfly nut (if a lock is present) until fully secured to the roof rails. Fit safety caps on both sides.

Watch the video!


by ScegliAuto

More videos