Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
In this video, learn how to perform the routine maintenance service by changing the oil and oil filter on a Suzuki GSX-S 1000. First, warm up the engine for a few minutes; then, unscrew any screws on the belly pan to remove it. Next, unscrew the engine oil drain bolt using a socket spanner, allowing the oil to drain into a container for about ten minutes; now, remove the oil filter with the appropriate tool and replace it with a new one. Finally, pour in the new oil, ensuring it is the correct type for your engine!

Updated on 3 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Coolant in the Suzuki GSX-S 1000
How to Replace the Coolant in the Suzuki GSX-S 1000
Gsx S 1000 .. and refill the antifreeze in the Suzuki GSX-S 1000 in simple steps. First, place your motorcycle on a stand and start removing the plastic fairing.. …
How to Replace the Fuel Tank of the Suzuki GSX-S 1000
How to Replace the Fuel Tank of the Suzuki GSX-S 1000
Gsx S 1000 .. and replace the fuel tank of the Suzuki GSX-S 1000 motorcycle. First, place the bike on a stand and remove the passenger and rider seats. Next, take.. …
How to Replace the Battery of the Suzuki GSX S 1000
How to Replace the Battery of the Suzuki GSX S 1000
Gsx S 1000 .. To replace the battery of the Suzuki GSX S 1000, remove the rear padding of the seat to access the screws underneath. Loosen these screws to remove.. …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos