Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Sym Voyager Gts 125
Part:

In this video tutorial, you will learn how to remove the front part or the entire front fairing on the Sym Voyager GTS 125 scooter, following the instructions below. First, remove the screws securing the mirrors, detaching them along with the arms; then unscrew the screws located underneath, as shown in the video. At this point, take off the first piece of the front fairing; now unscrew the screws from the footrest and the side screws to remove the entire shield, disconnecting the various electrical connectors. Follow the video to the end for reassembly!

Updated on 22 April 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Front Wheel of the Sym Voyager GTS 125
How to Remove the Front Wheel of the Sym Voyager GTS 125
Voyager Gts 125 In this brief and simple guide, you will learn how to remove the front wheel and replace the tyre of the Sym Voyager GTS 125 scooter, as well as the …
How do you disassemble the engine of the Sym Voyager GTS 125?
How do you disassemble the engine of the Sym Voyager GTS 125?
Voyager Gts 125 To disassemble the engine of the Sym Voyager GTS 125, you need to loosen the screws that secure the block to its housing, which is located at the cen…
How to Replace the Stator on the Sym Voyager GTS 125
How to Replace the Stator on the Sym Voyager GTS 125
Voyager Gts 125 In this video tutorial, you will learn how to remove and replace the electrical stator of the Sym Voyager GTS 125 scooter. First, place the scooter o…

Servicing a Honda SH300 Scooter

How to service the SH 300 scooter. This operation should be done with the engine cold. Remove the cover and take out the air filter, cleaning the compartment where the new one will be placed. Refit the three screws you removed earlier and reassemble the cover. Remove the oil cap, take a 12 mm spanner and unscrew the oil plug from underneath. Allow the oil to drain into a suitable container, which you will then dispose of at an authorised centre. Remove the filter, clean the cavity where the new one will be fitted, and tighten it with the spanner. Refit the oil cap screw. Always change the washer on the cap. Now, refill with oil. You will need a synthetic oil like Motul 5100 10W40, which costs £12.40 per litre on Amazon. If you are doing a complete change, you will need two cans, as you will require 1.6 litres including the filter. After adding the oil, let it rest for a few minutes, then run the engine for a few minutes and check the level. If necessary, top it up: it should be halfway between min and max.

Watch the video!


by ScegliAuto

More videos