Do it yourself
Frequently asked questions about cars and motorcycles
In today's tutorial video, you will see how to remove and replace the spark plug of the Sym Joymax 250 scooter engine, following the instructions below. First, place your scooter on the centre stand and begin by removing the plastic cover on the left side, near the footpeg. Next, disconnect the spark plug's electrical connector, using a socket wrench with an extension to unscrew and remove it, as shown in the video. At this point, replace the old spark plug with a new one of the same thread size, screwing it in by hand and tightening gently!

Updated on 31 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Joymax 250 To replace the spark plug on the Sym Joymax 250, loosen the screws securing the left side panel of the scooter, located just above the footwell. Once…
Joymax 250 Before starting, sit on the rider's seat of your Sym Joymax 250. Begin by turning the key in the ignition switch to power up the instrument panel. Ne…
Joymax 250 To replace the air filter on the Sym Joymax 250, loosen the screws securing the cover of the casing located near the rear wheel, just above the trans…

How to Change the Speed Unit on the Piaggio Mp3

If the speed displayed on your Piaggio Mp3 is in a unit of measurement different from your preference, simply follow this mini guide to change it independently. First, start this procedure with the bike completely off. Then, press and hold the "Mode" button on the right knob for about three seconds and turn on the display. Once done, press the "Mode" button again to switch between units (from Km/h to Mph or vice versa). Finally, hold down "Set" to save the changes.

Watch the video!


by ScegliAuto

More videos