Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Sym Fiddle
Part: Light bulb

This brief guide shows you how to remove and replace the front indicator bulbs by replacing the entire units on the Sym Fiddle 3 scooter. First, place your scooter on the centre stand and start unscrewing the screws securing the plastic shield, also removing the lower fairings; unscrew the screws found under the front nose to remove the entire shield and access the indicators, as shown in the video. Now disconnect the electrical connector of the indicator and remove the entire unit; then install the new indicators, following the video tutorial to the end!

Updated on 21 June 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Front Headlight from a Sym Fiddle
How to Remove the Front Headlight from a Sym Fiddle
Fiddle Before you can start, position your Sym Fiddle on its central stand. Begin by unscrewing and removing the screws that secure the front headlight to t…
Replacement of the front headlight bulb of the Sym Fiddle
Replacement of the front headlight bulb of the Sym Fiddle
Fiddle Today we will discover the instructions that will allow us to disassemble the headlight bulb of the Sym Fiddle front light. First, we put the scooter…
How to Replace the Exhaust on a Sym Fiddle
How to Replace the Exhaust on a Sym Fiddle
Fiddle In today's video, you will see the steps to remove and replace the exhaust on the Sym Fiddle scooter. First, position the scooter on the centre stand…

Servicing a Honda SH300 Scooter

How to service the SH 300 scooter. This operation should be done with the engine cold. Remove the cover and take out the air filter, cleaning the compartment where the new one will be placed. Refit the three screws you removed earlier and reassemble the cover. Remove the oil cap, take a 12 mm spanner and unscrew the oil plug from underneath. Allow the oil to drain into a suitable container, which you will then dispose of at an authorised centre. Remove the filter, clean the cavity where the new one will be fitted, and tighten it with the spanner. Refit the oil cap screw. Always change the washer on the cap. Now, refill with oil. You will need a synthetic oil like Motul 5100 10W40, which costs £12.40 per litre on Amazon. If you are doing a complete change, you will need two cans, as you will require 1.6 litres including the filter. After adding the oil, let it rest for a few minutes, then run the engine for a few minutes and check the level. If necessary, top it up: it should be halfway between min and max.

Watch the video!


by ScegliAuto

More videos