Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Key Shell of the Tata Zest

Model: Tata Zest MK 1 - Years 2014-2019
Part: Key

Today, in this video tutorial, you will see how to disassemble and replace the key fob of the Tata Zest, following the instructions below. First, take your key fob and start prying on the sides with something thin to open it into two parts. Then, unscrew the small screw of the key to remove it from the shell, as shown in the video. At this point, remove the battery and the electronic board, also taking out the chip. Then, install the components into the new key shell, following the video tutorial until the end!

Updated on 3 August 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Key Fob Battery of the Tata Zest
How to Replace the Key Fob Battery of the Tata Zest
Tata Zest (2014-2019 / MK 1) In this short and simple guide, you will see the steps to disassemble and replace the battery of the key fob for the Tata Zest. First, take your key …
How to Replace the Cabin Air Filter on Tata Zest
How to Replace the Cabin Air Filter on Tata Zest
Tata Zest (2014-2019 / MK 1) To replace the cabin air filter on the Tata Zest, you need to remove the panel on the side of the footwell on the driver's side, near the center cons…
How to Replace the Headlight Bulb on a Tata Zest?
How to Replace the Headlight Bulb on a Tata Zest?
Tata Zest (2014-2019 / MK 1) To replace the headlight bulb on a Tata Zest, open the hood to access the components inside the engine compartment. The bulb is located inside the he…

Other guides you may be interested in

Where is the Fuel Filter Located in a Volvo XC60?

In this video, you will see where the fuel filter is located in a Volvo XC60 and how to proceed if you need to replace it. As shown, the filter is positioned at the lower part of the engine, right between the left half-shaft and the sway bar attachment. To replace the filter, first, go underneath the vehicle, taking all necessary safety precautions. Then, using an 18mm wrench, open the drain valve and allow any water present to escape. Next, unscrew the housing, remove the old filter, insert the replacement along with a new gasket, and reassemble everything.

Watch the video!


by ScegliAuto

More videos