Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Use the Battery Reset Switch on the Hyundai Nexon

Model: Tata Nexon MK 1 - Years: 2017, 2018, 2019, 2020, 2021, 2022, 2023, 2024
Part: Battery

Video tutorial

In this video, see how to use the battery reset switch on a Hyundai Nexon vehicle: this vehicle has two batteries, a larger one that powers the drive system and a smaller 12-Volt battery for accessories and starting the vehicle. If for some reason the 12-Volt battery is dead, you can start the vehicle using the drive battery by pressing the 12-Volt battery reset switch located on the panel on the left side of the steering wheel, which allows 15 seconds to start the vehicle.

If you wait too long, you will need to press the switch again. To recharge the battery, drive the vehicle for at least thirty minutes or leave it in "Ready" mode in an open space for the same amount of time, which will allow the battery to recharge.


Updated on 26 September 2026 by ScegliAuto


Related tutorials

How to Replace the Remote Battery in the Tata Nexon?
Tata Nexon (2017-2024 / MK 1) In this tutorial, you will see how to replace the remote battery in the Tata Nexon, a very simple task. You will only need a small flathead screwdriv…
How to Replace the Key Fob Battery on the Tata Nexon?
How to Replace the Key Fob Battery on the Tata Nexon?
Tata Nexon (2017-2024 / MK 1) To replace the key fob battery on the Tata Nexon, press the button on the top of the device to release the key: once the key is released, pry open th…
How to Replace the Battery in a Tata Nexon?
How to Replace the Battery in a Tata Nexon?
Tata Nexon (2017-2024 / MK 1) To replace the battery in a Tata Nexon, open the hood to locate the new device in the upper right part of the engine compartment, just below the wind…

Other guides you may be interested in

How to Remove the Rear Seat of a Hyundai Tucson?

To remove the rear seat of a Hyundai Tucson, follow these steps. Start by moving the front seats to their most forward position to gain space. Next, locate the release lever on the underside of the rear seat, near the floor. Press this lever down while pulling the seat upwards to unlock it from the anchor pins. Once unlocked, tilt the seat upwards and forwards to remove it from its position. Repeat this process for both sides of the rear seat. Be careful of any electrical cables or components that may be connected to the seat during removal. Once the rear seat is removed, the disassembly is complete.

Watch the video!


by ScegliAuto

More videos