Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions
To adjust the suspension on the TM Racing SMR 125, consult the user and maintenance manual to understand how to properly tighten the bolts. To adjust the front suspension, tighten the compression screws located at the top of the fork according to the values indicated in the manual. The same procedure should be followed for the extension screws, which are located at the bottom of the fork. After adjusting the suspension, verify its correct operation during riding.

Updated on 12 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Replacing the Brake and Clutch Levers on TM Racing SMR 125
Replacing the Brake and Clutch Levers on TM Racing SMR 125
Smr 125 In this video tutorial, we will see how to dismantle and replace the brake and clutch levers on a TM Racing SMR 125 motorcycle. First, remove the clu…
How do you replace the exhaust pipe of the TM Racing SMR 125?
How do you replace the exhaust pipe of the TM Racing SMR 125?
Smr 125 It will be possible to replace the exhaust of the TM Racing SMR 125 by loosening the screws that secure the terminal to its housing, next to the fend…
How to replace the clutch actuator on the TM Racing SMR 125?
How to replace the clutch actuator on the TM Racing SMR 125?
Smr 125 To replace the clutch actuator on the TM Racing SMR 125, loosen the screws that secure it to its housing on the left side of the bike, right next to …

How to Check the Coolant Level in a Yamaha Xmax

In the following video, you will learn how to check the coolant level in a 2008 Yamaha Xmax. First, position the motorcycle on a stable surface by raising the stand. Next, lift the cover located at the top of the motorcycle to access the coolant drain bolt. To top up the coolant, unscrew the cap as shown in the video and add the fluid until it reaches the maximum level, indicated as Max. Once finished, close the valve and refit the cover. At this point, start the engine and let it run at idle for a few minutes to eliminate any air bubbles that may have formed inside.

Watch the video!


by ScegliAuto

More videos