Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to replace the third brake light bulb on the Toyota Tacoma?

Model: Toyota Tacoma N300 - Years 2016-2026
Part:

To replace the third brake light bulb on the Toyota Tacoma, you need to detach the headliner at the rear of the vehicle, also removing the clip located at this point. Once the headliner is detached, you can disconnect the third brake light housing from the inside, so the connector attached to it will disconnect. After removing the housing, you will need to pull out the bulb inside and replace it with a new one. After the replacement, you can reattach the housing, connecting and securing it properly.

Updated on 24 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the License Plate Bulb on a Toyota Tacoma
How to Replace the License Plate Bulb on a Toyota Tacoma
Toyota Tacoma (2016-2026 / N300) To replace the license plate light bulb on a Toyota Tacoma, access the underside of the rear bumper to disconnect the connector attached to the bulb.…
How to Replace the Stop Switch in a Toyota Tacoma Pickup?
How to Replace the Stop Switch in a Toyota Tacoma Pickup?
Toyota Tacoma (2005-2015 / N270, N260, N250, N240, N220, MK 2) Replacing the stop switch in a Toyota Tacoma is a very simple and quick operation. Let's see how to proceed in this tutorial. Before doing this, ensu…
How to Replace the Headlight Bulb on a Toyota Tacoma
How to Replace the Headlight Bulb on a Toyota Tacoma
Toyota Tacoma (2016-2026 / N300) Today, you will learn the steps to remove and replace the headlight bulb on a Toyota Tacoma. First, open the hood and start by removing the plastic c…

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos