Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing a Bumper End on a Third Generation Toyota Tacoma

Model: Toyota Tacoma N300 - Years 2016-2026
Part: Rear bumper

The video shows how to replace a rear bumper end on a third generation Toyota Tacoma. It is a fairly simple operation that can be done alone in a few steps. You will be replacing a damaged panel. Remove the three plastic clips located under the bumper end by prying them out with a screw. Remove the bumper end and while doing so, unscrew the parking sensor. Then, remove the sensor housing from the old end and insert it into the new one. Finally, reassemble the new end using the same steps described earlier, but in reverse order.

Updated on 4 June 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

Remove the Front Bumper of the Toyota Tacoma 2
Remove the Front Bumper of the Toyota Tacoma 2
Toyota Tacoma (2005-2015 / N270, N260, N250, N240, N220, MK 2) In this short and simple video, you will see how to remove the front bumper of the second generation Toyota Tacoma by following the instructions belo…
How to replace the third brake light bulb on the Toyota Tacoma?
How to replace the third brake light bulb on the Toyota Tacoma?
Toyota Tacoma (2016-2026 / N300) To replace the third brake light bulb on the Toyota Tacoma, you need to detach the headliner at the rear of the vehicle, also removing the clip locat…
How to Remove the Rear Bumper of a Toyota Tacoma?
How to Remove the Rear Bumper of a Toyota Tacoma?
Toyota Tacoma (2005-2015 / N270, N260, N250, N240, N220, MK 2) To remove the rear bumper of a Toyota Tacoma, access the screws that secure it at the bottom by getting under the vehicle. Once these screws are loos…

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos