Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Remove the Rear Bumper of a Toyota Tacoma?

Model: Toyota Tacoma MK 2, N220, N240, N250, N260, N270 - Years: 2005, 2006, 2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015
Part: Rear bumper

See other generations:
Video tutorial

To remove the rear bumper of a Toyota Tacoma, access the screws that secure it at the bottom by getting under the vehicle. Once these screws are loosened, you can pull out the license plate lights from their housing, disconnecting their connectors as well.

After these components are removed, loosen the two bolts directly beneath the license plate so the bumper can be completely removed. This will allow you to install the new piece, securing it with the appropriate brackets.


Updated on 12 May 2026 by ScegliAuto


Related tutorials

Replacing a Bumper End on a Third Generation Toyota Tacoma
Toyota Tacoma (2016-2026 / N300) The video shows how to replace a rear bumper end on a third generation Toyota Tacoma. It is a fairly simple operation that can be done alone in a few…
Remove the Front Bumper of the Toyota Tacoma 2
Remove the Front Bumper of the Toyota Tacoma 2
Toyota Tacoma (2005-2015 / MK 2, N220, N240, N250, N260, N270) In this short and simple video, you will see how to remove the front bumper of the second generation Toyota Tacoma by following the instructions belo…
How to Replace the License Plate Bulb on a Toyota Tacoma
How to Replace the License Plate Bulb on a Toyota Tacoma
Toyota Tacoma (2016-2026 / N300) To replace the license plate light bulb on a Toyota Tacoma, access the underside of the rear bumper to disconnect the connector attached to the bulb.…

How to Open the Hood of the BMW X3

Today, you will learn how to open and close the hood of the BMW X3. To perform this simple operation, lift the hood release lever located next to the door seal on the driver’s side. After pulling the lever, you will notice that the hood will lift slightly. Position yourself in front of the hood and lift it after moving the internal lever from left to right. To keep the hood secure during maintenance, use the side support rod. To close the hood, simply let it fall back into place.

Watch the video!


by ScegliAuto

More videos