Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Boot Light Bulb of the Toyota Corolla

Model: Toyota Corolla MK 2 - Years 2000-2007
Part: Light bulb

Follow these instructions to remove and replace the light bulb in the boot of the Toyota Corolla. First, open the rear boot lid and begin to unclip the bulb holder along with the bulb; then disconnect the electrical connector of the light, replacing the bulb with a new one, as shown in the video. Now install the bulb in the correct orientation and reassemble the bulb holder; the bulb should light up as soon as it is connected, as the boot lid will be open.

Updated on 26 July 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Brake Light Bulbs on a Toyota Corolla
How to Replace the Brake Light Bulbs on a Toyota Corolla
Toyota Corolla (2006-2013 / MK 3) In today's video, you will learn how to replace the rear brake light bulbs on a Toyota Corolla. First, obtain a replacement bulb, following the manuf…
How to Replace the Number Plate Bulb on a Toyota Corolla
How to Replace the Number Plate Bulb on a Toyota Corolla
Toyota Corolla (2013-2019 / MK 4, E170, E160) To replace the number plate bulb on a Toyota Corolla, open the boot to access the internal rivets. Remove these rivets to shift the carpet, allowing …
How to Replace the Rear Light Bulb of the Toyota Corolla?
How to Replace the Rear Light Bulb of the Toyota Corolla?
Toyota Corolla (2013-2019 / MK 4, E170, E160) To replace the rear light bulb of the Toyota Corolla, you need to detach the two pins located inside the boot, accessible by opening the rear hatch. …

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos