Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Installation of the OEM Step for Toyota Highlander 2021

Model: Toyota Highlander Xu70 - Years: 2020, 2021, 2022, 2023, 2024, 2025, 2026
Part: Checks and maintenance

See other generations:
Video tutorial

As shown in the video, before installing a step on your 2021 Toyota Highlander, remove two screws with a Torx screwdriver and a rear bolt using a 10 mm spanner. Use a lever to detach the three anchors located under the bumper.

Remove the trim. Take out a plastic hook and replace it with a piece that comes with the Toyota step, which will allow you to screw in the bolt to support the step itself.

Seal any open areas and proceed as shown in the video. Fit the step by tightening the necessary screws.

It is advisable to follow the manufacturer's instructions to the letter.


Updated on 3 August 2026 by ScegliAuto


Related tutorials

How do you replace the cabin filter of the Toyota Highlander?
How do you replace the cabin filter of the Toyota Highlander?
Toyota Highlander (2020-2026 / Xu70) It will be possible to replace the cabin filter of the Toyota Highlander by opening the glove compartment located on the passenger side: in this way …
How to Replace the Wiper Blades on a Toyota Highlander?
How to Replace the Wiper Blades on a Toyota Highlander?
Toyota Highlander (2001-2007 / Xu20) To replace the wiper blades on a Toyota Highlander, lift the arm of the respective blade so that it does not contact the windscreen. Once lifted, use…
How to Replace the Cabin Filter on the Toyota Highlander?
How to Replace the Cabin Filter on the Toyota Highlander?
Toyota Highlander (2001-2007 / Xu20) To replace the cabin filter on the Toyota Highlander, open the glove compartment located on the passenger side; then, detach the side clips securing …

How to Open the Bonnet on the Mitsubishi L200?

In this tutorial, you will see how to open the bonnet on the Mitsubishi L200, a very simple operation that follows the standard procedure. First, open the vehicle and go to the driver's side, then locate the lever at the lower outer area, just in front of the pedals, and pull it. Next, position yourself in front of the bonnet, locate the second lever above the Mitsubishi logo, and push it to the right, releasing the latch. At this point, you can fully lift the bonnet and secure it with the prop rod.

Watch the video!


by ScegliAuto

More videos