Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Open a Stuck Fuel Door in a Toyota Innova?

Model: Toyota Innova Kijang Crysta An140 - Years: 2015, 2016, 2017, 2018, 2019, 2020, 2021, 2022, 2023
Part: Fuel cap

See other generations:
Video tutorial

In the Toyota Innova, the fuel door may get stuck, for example, due to a faulty button or lock actuator. In these cases, you can perform an emergency opening by following the simple procedure shown in this tutorial.

First, open the trunk. Then, locate the panel on the left side and remove it. Next, grasp the actuator cable, disconnect it by turning it slightly counterclockwise, and open the fuel door.

At this point, you can refuel and repair the faulty component.


Updated on 15 September 2026 by ScegliAuto


Related tutorials

How to Reset the AdBlue Light on the Toyota Innova?
How to Reset the AdBlue Light on the Toyota Innova?
Toyota Innova Kijang Crysta (2015-2023 / An140) To reset the AdBlue light on the Toyota Innova, you need to refill the tank, as the light comes on when the fluid level is low. Open the hood to acce…
How to Reset the AdBlue Warning Light on the Toyota Innova?
How to Reset the AdBlue Warning Light on the Toyota Innova?
Toyota Innova Kijang Crysta (2015-2023 / An140) The AdBlue warning light that illuminates on the instrument panel of the Toyota Innova indicates that the additional fluid in the tank is almost comp…
How to Replace the Alternator on a Toyota Innova
How to Replace the Alternator on a Toyota Innova
Toyota Innova Kijang Crysta (2015-2023 / An140) To replace the alternator on a Toyota Innova, open the hood to access the components inside the engine compartment. First, disconnect the battery pow…

How to Reset the Tire Pressure Light on a MG ZS?

On the instrument cluster of the MG ZS, the tire pressure light that appears can be reset by inflating the tires to the correct pressure: this value will be indicated on the sticker attached to the driver's door pillar. Once the tires have been properly inflated, you can turn on the instrument cluster and navigate through the menu until you find the option that indicates tire pressure: if this screen shows the new values, the light will turn off; otherwise, you will need to drive for a few miles so that the sensors can read the new values and turn off the light afterward.

Watch the video!


by ScegliAuto

More videos