Do it yourself
Frequently asked questions about cars and motorcycles

How to install parking sensors on the Toyota Corolla

Model: Toyota Corolla MK 2 - Years 2000-2007
Part: Parking sensors

To install parking sensors in the Toyota Corolla, we start by making marks with adhesive tape on the rear bumper of the car; once the marks are made, we drill holes in the bumper with the provided tip in the kit, insert the sensors into the holes, run the sensor cables into the interior underneath the trunk; we secure the sensor control unit, connect the cables, connect the reverse wire to the control unit and run the display cables that should be placed in the front, underneath the trunk, run the cables on the upper pillars of the car by releasing them, until reaching the front upper pillar, then run the cable in the lower part of the dashboard until reaching where we want to position the display. Once all connections are made, also connected the power, start the car engine, engage reverse gear and then reverse the car or with the reverse gear engaged, walk behind the car to verify that the sensors are working properly.

Posted on 24 June 2024 by ScegliAuto

Video tutorial

Related tutorials

Toyota Corolla (2019-2026 / MK 5, E210) To deactivate the parking sensors on the Toyota Corolla Cross, you need to turn on the instrument panel by inserting the ignition key: then you will …
Toyota Corolla (2019-2026 / MK 5, E210) These short and simple instructions will show us how to enable and disable the parking sensors of the Toyota Corolla. First, we get into the car and …
Toyota Corolla (2019-2026 / MK 5, E210) In this guide, we will check the tire pressures and how to reset the TPMS sensors on the Toyota Corolla. To perform this type of check, it is necessa…

Other guides you may be interested in

How to Open a Stuck Boot on the Peugeot 407?

On the Peugeot 407, the boot may become stuck, possibly due to a problem with the control button or the lock actuator. In such cases, you can perform an emergency opening by following the simple procedure shown in this tutorial. First, open the rear doors, then lower the seat back by operating the release lever. Next, go inside the boot, locate the lock, and manually operate it using a flathead screwdriver. The boot will then be free to open.

Watch the video!


by ScegliAuto

More videos