|
Do it yourself
| |||
| ||||
How to disassemble the fairing of the mirror on a Hymer camper
Model: (Various brands) Hymer
In this video, we will see how to disassemble the fairings of the vibrating rearview mirror of Hymer campers. First, we will need to remove the upper fairing. Covered by two black rubber caps, we will find crosshead screws that, once removed, will allow us to take off this small fairing; let's take the opportunity to check that all the screws inside are tightly closed and that the vibration does not come from there. Below, there is the joint, which could be moving too much and therefore vibrating, and to reach it we must disassemble the upper mirror, lifting it all the way up; underneath, we will find a lever that will allow us to detach the glass/mirror from its support. The lower mirror instead just needs to be pulled towards us, but in a very straight manner. Now we need to remove the cover, unscrewing all the screws around it, in order to access the central pin, which allows us to open and close the mirror. We can tighten it a little, to eliminate the play that we see it is currently doing, and which is the reason why it vibrates.
Posted on 12 June 2025 by ScegliAuto
Video tutorial
Related tutorials
Smart
(2007-2015 /
451)
Disassembly of the damaged mirror? Is the mirror mounted inside a mirror on a Smart Fortwo? Let's see how the mirror is removed from above. With a pl…
Volvo S70
(1996-2000 /
MK 1)
Is the rear view mirror of the Volvo S70 broken? Let's see how the outside rearview mirror is removed from above. We pry between the mirror and the m…
Citroen C4 Picasso
(2006-2013 /
MK 1)
Disassembling the cover of the Citroen C4 Grand Picasso? We remove the cover to replace it or to work inside the mirror. We close the mirror to make …
Other guides you may be interested in
|
How to Replace the Lift Supports on a Porsche 911
How to remove and replace the lift supports for the hood on a Porsche 911? Let's see how to replace them in this video: Lift the hood and secure it. Use a screwdriver or metal lever to detach the clips that hold the lift support at both ends (or unscrew the mounting pins). Install the new part onto the sheet metal of the front trunk, securing the lift support with the clips/pins. Proceed in the same manner for the removal/installation of the opposite lift support. Finally, test the gas springs installed earlier. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.047
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |
