|
Do it yourself
| |||
| ||||
Timing belt replacement for Volkswagen Golf VII
Model: Volkswagen Golf
Golf VII, MK 7, Golf 7
- Years 2012-2019
In this video we can see the bench replacement of the oil belt and water pump of a Volkswagen Golf VII: we will start from its rear by draining the coolants and setting the top dead center of cylinder number one. This engine uses a separate timing belt for the water pump, and it must be replaced every time the timing belt is replaced; the bolts must be loosened in a certain sequence: start from the other and proceed counterclockwise. Now we are able to remove the water pump and thermostat together with the belt. When mounting the gasket, we must pay attention to its mounting tabs; the water pump must undergo a particular tensioning, as we must apply a load of 30 Nm with a 10mm hex key, following the opposite sequence to the disassembly, tightening them to 10Nm, and then loosening them by one turn. In the lower part we have a hexagonal cavity where we must preload 30Nm, which must be maintained until the pump is completely bolted. We must then have someone help us in this phase. Follow the indications of the various bolt tightening sequences of the pump, as illustrated in the video: they are very important.
Posted on 13 February 2025 by ScegliAuto
Video tutorial
Related tutorials
Volkswagen Golf
(2012-2019 /
Golf VII, MK 7, Golf 7)
Today's main information will show you how and when to replace the timing belt on a Volkswagen Golf 1.4 TSI. For this type of engine, the timing belt…
Volkswagen Golf
(2012-2019 /
Golf VII, MK 7, Golf 7)
Hello! Today, replace the timing belt on your Volkswagen Golf. First, position the car on a flat surface and ensure the engine is cold. Carefully rem…
Volkswagen Golf
(2012-2019 /
Golf VII, MK 7, Golf 7)
Below we will discover information on how to disassemble and replace the timing belt of the Volkswagen Golf 1.6 TDI; the manufacturer states that, on…
Other guides you may be interested in
|
How to Connect the Cables to the Battery of the Citroen Xsara Picasso?
In this tutorial, you will see how to connect the cables to the battery of the Citroen Xsara Picasso, useful if you need to recharge it or perform an emergency start. First, ensure the key is not inserted, then open the bonnet and move to the front of the left headlamp. Next, locate the bolt just behind the filter box and connect the positive terminal clamp to it. Now you can connect the negative terminal to any point on the chassis, such as the indicated point. Once the operation is complete, ensure you disconnect the negative first and then the positive. by ScegliAuto More videos
|
|
For advertising on this site Write to info@scegliauto.com
ScegliAuto is not responsible for any inaccuracy of the data in the lists. To report any inaccuracy or your business (if you own the business in question), please write to info@scegliauto.com
Number of seconds to generate the page: 0.189
(c) ScegliAuto 2026 - info@scegliauto.com - Privacy policy VAT number: IT01247470535 |