Do it yourself
Frequently asked questions about cars and motorcycles

How to Replace the Rear Wiper Motor on a Volkswagen Golf IV

Model: Volkswagen Golf Golf IV, Golf 4, MK 4 - Years: 1997, 1998, 1999, 2000, 2001, 2002, 2003
Part: Windshield wipers

See other generations:
Video tutorial

In this video tutorial, you will see how to replace the rear wiper motor on a Volkswagen Golf IV by following a few simple steps. To carry out this task, you will need a quarter-inch ratchet (with 13 mm and 10 mm sockets), a wiper arm puller, a combination pliers, and a star screwdriver.

The wiper motor is bolted inside the tailgate, so you need to dismantle it. Start by removing the cap located at the bottom of the wiper arm; use the pliers to pull out the nozzle, then unscrew the central nut. Now, using the puller, remove the wiper arm (or you can gently wiggle it off). Once the wiper arm is removed, use the star screwdriver to take out the screws securing the panel (as shown in the video).

After removing the two screws, you can detach the panel by hand.

Once the panel is removed, you will find the wiper motor. Disconnect the plug for the windscreen washer system, then loosen the three nuts (10 mm socket); now you can take out the motor.

Continue watching the video.


Updated on 6 July 2026 by ScegliAuto


Related tutorials

Volkswagen Golf (2003-2008 / Golf 5, MK 5, Golf V) Today, this guide will provide the instructions needed to remove and replace the rear wiper blade on the Volkswagen Golf. First, move to the rear of …
Volkswagen Golf (2008-2012 / Golf 6, MK 6, 5K1, Golf VI) In this video, learn how to remove the rear wiper motor from a sixth-generation Volkswagen Golf in simple steps. First, open the boot and remove the …
Volkswagen Golf (2003-2008 / Golf 5, MK 5, Golf V) In this video tutorial, you will learn how to remove the wiper arm along with the rear wiper on a fifth generation Volkswagen Golf by following these…

How to Open the Bonnet on the Mitsubishi L200?

In this tutorial, you will see how to open the bonnet on the Mitsubishi L200, a very simple operation that follows the standard procedure. First, open the vehicle and go to the driver's side, then locate the lever at the lower outer area, just in front of the pedals, and pull it. Next, position yourself in front of the bonnet, locate the second lever above the Mitsubishi logo, and push it to the right, releasing the latch. At this point, you can fully lift the bonnet and secure it with the prop rod.

Watch the video!


by ScegliAuto

More videos