Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Volkswagen
    3. :
  3. Polo
    4. : How to remove the front headlights of Polo 5.

Volkswagen Polo - Video tutorial

Model: Volkswagen Polo Polo V, MK V, 6R, Polo 5, MK 5 - Years 2009-2017
Part: Headlight
Operation: How to remove the front headlights of Polo 5.

Removing the front headlights of the Volkswagen Polo 5, produced until 2017, is an operation that can be done independently in a few minutes. The steps to follow are simple; just open the front hood of your car and proceed to remove the headlight. Let's start by removing the two Torx screws, using a T8. Once the screws are removed, you can extract the headlight by applying a slight force. Disconnect the connector and insert the new bulb inside the headlight. Once the bulb is inserted and you have verified that it works, you can proceed with mounting the headlight. Insert the headlight and push it towards the inside. Screw in the screws and close the hood.


Posted on 6 May 2023 by ScegliAuto

    Frequently Asked Questions

    • Polo 2001-2009 - How do you replace the front headlight of the Volkswagen Polo 8? Read Answer
    • Polo 2001-2009 - How much does the right headlight of a Volkswagen Polo cost? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos