Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Open the Blocked Charging Port on a Volkswagen ID.4?

Model: Volkswagen Id 4 MK 1 - Years 2020-2026
Part: Checks and maintenance

In your Volkswagen ID.4, the charging port door may become stuck, possibly due to a fault with the control button or the lock actuator. In this case, you can perform an emergency opening by following the simple procedure shown in this video. First, open the boot. Then, locate the small door on the right side of the compartment and open it. Next, grab the yellow cord and pull it towards the rear of the vehicle to unlock the lock. At this point, you can refuel and repair the faulty component.

Updated on 17 September 2026 by ScegliAuto

This video is currently unavailable

Related tutorials

How to open the door of the Volkswagen ID 4 when the remote battery is dead.
How to open the door of the Volkswagen ID 4 when the remote battery is dead.
Volkswagen Id 4 (2020-2026 / MK 1) When the battery of the Volkswagen ID 4 remote control is dead, accessing the vehicle may seem impossible, but in reality, using the emergency key ma…
Forced opening of the Volkswagen ID 4 charging port
Forced opening of the Volkswagen ID 4 charging port
Volkswagen Id 4 (2020-2026 / MK 1) The Volkswagen ID 4 is an electric vehicle equipped with an electric motor powered by batteries that need to be recharged from the electrical grid, t…
How do you replace the battery of the Volkswagen ID.4 remote control?
How do you replace the battery of the Volkswagen ID.4 remote control?
Volkswagen Id 4 (2020-2026 / MK 1) In order to replace the battery of the Volkswagen ID.4 remote control, you need to remove the key inside the device so that you can then pry open its…

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos