Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Replacing the rear brake light switch on the Volkswagen Jetta

Model: Volkswagen Jetta MK 5, A5 - Years 2005-2010

Below are the main instructions useful for removing and replacing the rear brake light switch on the Volkswagen Jetta, as well as the Golf. First, open the driver's side front door and start locating the stop switch; you will find it behind the brake pedal, where you simply need to detach it and disconnect its electrical connector to remove it, as illustrated in the video. At this point, install the new stop switch, as well as the original one, ensuring that the stop light comes on when you press the brake pedal!

Updated on 20 September 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Remove the Light Switch on a Volkswagen Jetta
How to Remove the Light Switch on a Volkswagen Jetta
Volkswagen Jetta (2010-2018 / MK 6, A6) Before you can start, sit in the driver's seat of your Volkswagen Jetta. Begin by pressing and holding the light switch. While doing this, rotate it …
Removing the Rear Light of the Volkswagen Jetta
Removing the Rear Light of the Volkswagen Jetta
Volkswagen Jetta (2005-2010 / MK 5, A5) Let's look at how to remove the rear light of the VW Jetta. Lift the rear hatch and secure it, then remove the fabric cover that protects the boot li…
Where are the Fuses Located in a Volkswagen Jetta?
Where are the Fuses Located in a Volkswagen Jetta?
Volkswagen Jetta (2018-2025 / A7, MK 7) Inside the Volkswagen Jetta, all fuses are contained within dedicated fuse boxes installed in the vehicle: in this type of car, you can find two boxe…

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos