Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to disassemble the third brake light in the Volkswagen Jetta?

Model: Volkswagen Jetta A7, MK 7 - Years 2018-2025
Part:

In this tutorial we can see how to remove the third brake light in the Volkswagen Jetta, an extremely simple and fast operation. First of all, make sure that the key is not inserted, then open the rear door, retrieve the tools provided and locate the slot on the upper side of the trunk. Next, disconnect the power connector of the light, unscrew the two fixing screws and remove the spotlight from the housing. At this point, all that remains is to position the replacement, screw in the screws and reconnect the connector.

Posted on 24 June 2024 by ScegliAuto

Video tutorial

Related tutorials

Replacing the rear brake light switch on the Volkswagen Jetta
Replacing the rear brake light switch on the Volkswagen Jetta
Volkswagen Jetta (2005-2010 / MK 5, A5) Below are the main instructions useful for removing and replacing the rear brake light switch on the Volkswagen Jetta, as well as the Golf. First, op…
How to replace the handbrake cable of the Volkswagen Jetta
How to replace the handbrake cable of the Volkswagen Jetta
Volkswagen Jetta (1998-2005 / A4, MK 4) Today's step-by-step instructions will show us how to disassemble and replace the handbrake cable of the Volkswagen Jetta. First, lift the car and st…
How to replace the rear brake pads of the Volkswagen Jetta.
How to replace the rear brake pads of the Volkswagen Jetta.
Volkswagen Jetta (2018-2025 / A7, MK 7) The instructions in this guide will show us how to disassemble and replace the rear brake pads of the Volkswagen Jetta. First, let's lift the vehicle…

How to Repair the Key Spring of the Peugeot 207?

Over time, frequent use of the key's flip mechanism in the vehicle, dozens of times a day, inevitably leads to wear of the internal spring. As shown in this video, replacing the spring is quite simple and takes little time. After opening the casing halfway, first position the key, then the spring housing, and finally insert the spring into the previously mentioned housing. Close the casing by rotating it clockwise, ensuring all components fit perfectly, and test the key's flip mechanism.

Watch the video!


by ScegliAuto

More videos