Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Turn Signal Lever on the Volvo S60 MK1

Model: Volvo S60 MK 1 - Years 2000-2009

Today, we will see step-by-step instructions to remove and replace the turn signal lever, which also applies to the wiper lever, on the Volvo S60, as well as on the S80, V70, XC70, and XC90. Get inside the vehicle and start by unscrewing the screws securing the steering column cover using a torx screwdriver; then disconnect the electrical connector of the switch by unscrewing the screws at the base with a Phillips screwdriver, as shown in the video. At this point, remove and replace the lever, reassembling everything!

Updated on 30 May 2026 by ScegliAuto

Video tutorial

Related tutorials

How to Replace the Side Turn Signal Bulb on a Volvo S60
How to Replace the Side Turn Signal Bulb on a Volvo S60
Volvo S60 (2010-2018 / MK 2) If one or both of the side turn signals on your Volvo S60 are not functioning properly and you want to replace them, just follow this procedure. Firs…
Replacing the Wiper Lever on the Volvo S60 - V70 MK1
Replacing the Wiper Lever on the Volvo S60 - V70 MK1
Volvo S60 (2000-2009 / MK 1) In this short video, see the main instructions to remove and replace the wiper lever or actuator rod on the Volvo S60, as well as on the V70. First, …
How to Reset the Service Light on a Volvo S60?
How to Reset the Service Light on a Volvo S60?
Volvo S60 (2010-2018 / MK 2) To reset the Service light on a Volvo S60, turn on the ignition, ensuring that the display shows the code T2 followed by its numerical value. Then, p…

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos