Do it yourself
Frequently asked questions about cars and motorcycles

Replacing the Wiper Lever on the Volvo S60 - V70 MK1

Model: Volvo S60 MK 1 - Years 2000-2009

In this short video, see the main instructions to remove and replace the wiper lever or actuator rod on the Volvo S60, as well as on the V70. First, get inside the vehicle and start by removing the plastic cover located between the steering wheel and the instrument panel; pry at the sides to detach it, as shown in the video. At this point, disconnect the electrical connector of the wiper lever by pressing the tab; then remove it and replace it with the new one, following the video tutorial to the end!

Updated on 30 May 2026 by ScegliAuto

Video tutorial

Related tutorials

Volvo S60 (2000-2009 / MK 1) Today, we will see step-by-step instructions to remove and replace the turn signal lever, which also applies to the wiper lever, on the Volvo S60, as…
Volvo S60 (2000-2009 / MK 1) Replace the burnt-out bulbs in the rear light on a Volvo S60. Open the trunk of the Volvo and remove the fabric side panel; you will find the bulb ho…
Volvo S60 (2010-2018 / MK 2) Today, let's go over the main instructions on how to remove and replace the timing belt on the Volvo S60 with a 2.0L engine. In this case, the timing…

Other guides you may be interested in

How to Check the Oil Level on a Jeep Renegade?

To check the oil level on a Jeep Renegade, you need to open the bonnet to access the components inside the engine bay: on the lower left side of the engine block, you will find the dipstick for checking the level. This should be pulled out and thoroughly cleaned with a cloth: once cleaned, reinsert it back into its tube and pull it out immediately after. This way, you can check that the oil mark is between the minimum and maximum levels; finally, you can place the dipstick back in its tube.

Watch the video!


by ScegliAuto

More videos