Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How do you reset the V-Belt warning light on the Yamaha Xmax 250?

Model: Yamaha Xmax 250
Part: Checks and maintenance

Video tutorial

You can reset the V-Belt warning light on the instrument panel of the Yamaha Xmax 250 by inserting the key into the corresponding slot and turning it to turn on the instrument panel. To turn off the warning light, you will need to pull the lever located at the base of the right handlebar towards the inside of the vehicle.

By holding down this lever, the warning light will start flashing until the remaining kilometers until the next replacement are reset. Once the kilometers have been reset, you can release the lever and turn off the instrument panel by turning the key in the opposite direction.


Posted on 11 June 2025 by ScegliAuto


Related tutorials

How to reset the belt replacement indicator on the Yamaha Xmax 250
How to reset the belt replacement indicator on the Yamaha Xmax 250
Xmax 250 In this guide we will see the steps that will allow us to reset the replacement belt warning light of the Yamaha Xmax 250 scooter. First, we put the …
How to Reset the V-BELT Warning Light on the Yamaha XMAX 250 Scooter?
How to Reset the V-BELT Warning Light on the Yamaha XMAX 250 Scooter?
Xmax 250 In this tutorial, you will learn how to reset the service indicator for the drive belt on the Yamaha XMAX 250 scooter, indicated by the V-BELT warnin…
How to Reset the V-Belt Light on the Yamaha Xmax 250?
How to Reset the V-Belt Light on the Yamaha Xmax 250?
Xmax 250 To reset the V-Belt light on the Yamaha Xmax 250, you need to disconnect the connector related to the sensor that monitors the wear of the belt. This…

How to replace the transmission oil in the KTM Exc 300

Today, let's discover how to carry out the routine maintenance service by replacing the transmission oil in the two-stroke enduro bike KTM Exc 300. First, place your bike on a stand and start by unscrewing the oil drain bolt located under the engine, allowing the gearbox oil to drain into a container for about ten minutes; then clean the small mesh oil filter, as shown in the video. At this point, unscrew the filler cap and top up with the new gearbox oil, the specifications of which are indicated in the owner's manual!

Watch the video!


by ScegliAuto

More videos