Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Yamaha Majesty 400
Part: Engine

Today we will discover the instructions that will allow us to disassemble and remove the engine from the frame of the Yamaha Majesty 400 scooter. First, let's put the scooter on the central stand and start by disconnecting the rear suspensions from the frame by unscrewing the upper screws; then we will remove the under-seat compartment and the rear fender, as shown in the video. At this point, let's disconnect the fuel and throttle lines and also disconnect the engine support and the silent blocks; then we will separate the frame and the bodywork from the engine block, following the video tutorial until the end!

Posted on 7 December 2025 by ScegliAuto

Video tutorial

Related tutorials

Guide to Removing the Fuel Pump on a Yamaha Majesty 400
Guide to Removing the Fuel Pump on a Yamaha Majesty 400
Majesty 400 In this guide, you will find the main instructions for removing and replacing the fuel pump on the Yamaha Majesty 400 scooter. First, remove the seat…
How to Reset the Drive Belt Warning Light on the Yamaha Majesty 400
How to Reset the Drive Belt Warning Light on the Yamaha Majesty 400
Majesty 400 If you notice the drive belt warning light on the dashboard of your Yamaha Majesty 400, do not worry because with the following guide you will be abl…
How to replace the battery of the Yamaha Majesty 400
How to replace the battery of the Yamaha Majesty 400
Majesty 400 In a few simple steps, we will see how to disassemble and replace the battery of the Yamaha Majesty 400. First, lift the seat and start unscrewing th…

How to replace the engine oil in the Ducati Monster S2R 1000?

In this tutorial we can see how to replace the motor oil in the Ducati Monster S2R 1000, an extremely simple and fast operation. First of all, make sure that the engine is cold enough, then place a container underneath it, locate the drain plug and unscrew it using a hex key. Next, unscrew the cap of the secondary filter, remove it and clean it from any dirt residue. At this point, all that remains is to unscrew the main filter, tighten the replacement, reassemble everything and pour in the new oil through the appropriate hole.

Watch the video!


by ScegliAuto

More videos