Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to change the brake pads on a Yamaha YBR 125

Model: Yamaha Ybr 125
Part: Brake pads

Video tutorial

In this video, we will see how to change the brake pads on a Yamaha YBR 125: start by removing the side screw from the flexible hose, then take out the screws visible from the outside of the fork. Remove the brake caliper, and with the help of a screwdriver, take out the pads from the brake, first the outer one then the inner one. Next, take the new pads and place them inside the caliper, starting with the inner one, followed by the outer one. Then, insert the pin into its hole and reposition the caliper in its housing, replace the bolts on the fork, and finally, put the side screw back on the flexible hose.


Posted on 5 April 2026 by ScegliAuto


Related tutorials

How to Replace the Front Brake Pads on a Yamaha YBR 125?
How to Replace the Front Brake Pads on a Yamaha YBR 125?
Ybr 125 To replace the front brake pads on a Yamaha YBR 125, loosen the screws that secure the brake caliper to the corresponding disc, allowing it to be com…
How to Dismantle the Rear Wheel of a Yamaha YBR 125
How to Dismantle the Rear Wheel of a Yamaha YBR 125
Ybr 125 Below are the instructions that will allow you to dismantle and remove the rear wheel of the Yamaha YBR 125. First, place the bike on a stand and sta…
How to Replace the Battery on a Yamaha YBR 125
How to Replace the Battery on a Yamaha YBR 125
Ybr 125 To replace the battery on a Yamaha YBR 125, insert the key into the lock located on the left side of the bike, just below the seat. This will allow y…

How to change the engine oil of a Yamaha MT-07?

To change the engine oil of a Yamaha MT-07, follow these steps. Start by placing the bike on a flat surface and ensure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine casing, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, refit the drain plug. Remove and replace the oil filter using an oil filter spanner. Apply a little new oil to the seal of the new filter before installation. Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary. Refit the oil cap and ensure it is securely tightened. Start the engine and let it run for a few minutes to distribute the oil, and you will have completed the procedure.

Watch the video!


by ScegliAuto

More videos