Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace the Front Brake Pads on a Yamaha YBR 125?

Model: Yamaha Ybr 125
Part: Brake pads

Video tutorial

To replace the front brake pads on a Yamaha YBR 125, loosen the screws that secure the brake caliper to the corresponding disc, allowing it to be completely detached. Once removed from its housing on the disc, you can extract the old pads from inside the caliper by removing the pin that holds them in place.

Now, insert the new pads into the caliper and reposition it on the disc, securing it with the appropriate screws; after installation, operate the brakes to ensure they function correctly.


Updated on 29 July 2026 by ScegliAuto


Related tutorials

How to change the brake pads on a Yamaha YBR 125
How to change the brake pads on a Yamaha YBR 125
Ybr 125 In this video, we will see how to change the brake pads on a Yamaha YBR 125: start by removing the side screw from the flexible hose, then take out t…
How to Replace the Brake Light Bulb on a Yamaha YBR 125?
How to Replace the Brake Light Bulb on a Yamaha YBR 125?
Ybr 125 Replacing the brake light bulb on the Yamaha YBR 125, as shown in this tutorial, is an extremely simple and quick task. Before proceeding, ensure tha…
How to Dismantle the Rear Wheel of a Yamaha YBR 125
How to Dismantle the Rear Wheel of a Yamaha YBR 125
Ybr 125 Below are the instructions that will allow you to dismantle and remove the rear wheel of the Yamaha YBR 125. First, place the bike on a stand and sta…

How to change the engine oil of a Yamaha MT-07?

To change the engine oil of a Yamaha MT-07, follow these steps. Start by placing the bike on a flat surface and ensure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine casing, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, refit the drain plug. Remove and replace the oil filter using an oil filter spanner. Apply a little new oil to the seal of the new filter before installation. Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary. Refit the oil cap and ensure it is securely tightened. Start the engine and let it run for a few minutes to distribute the oil, and you will have completed the procedure.

Watch the video!


by ScegliAuto

More videos