Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

How to Replace Front Indicators on Yamaha YBR 125G

Model: Yamaha Ybr 125
Part: Light bulb

Video tutorial

In this video, follow these simple steps to remove and replace the original indicators on a Yamaha YBR 125G motorcycle. First, remove the front headlamp by unscrewing the side fixing screws to access the front indicators; then disconnect the electrical connectors of the bulbs.

Next, unscrew the fixing bolt of the indicators, removing them from the side brackets; now proceed to fit the new indicators, connecting the wires to the lighting system, and then reassemble the headlamp!


Updated on 5 May 2026 by ScegliAuto


Related tutorials

How to Dismantle the Rear Wheel of a Yamaha YBR 125
How to Dismantle the Rear Wheel of a Yamaha YBR 125
Ybr 125 Below are the instructions that will allow you to dismantle and remove the rear wheel of the Yamaha YBR 125. First, place the bike on a stand and sta…
How to Replace the Clutch on a Yamaha YBR 125?
How to Replace the Clutch on a Yamaha YBR 125?
Ybr 125 To replace the clutch on the Yamaha YBR 125, loosen the screws securing the cover located on the right side of the bike at the front. Once the cover …
How to Replace the Battery on a Yamaha YBR 125
How to Replace the Battery on a Yamaha YBR 125
Ybr 125 To replace the battery on a Yamaha YBR 125, insert the key into the lock located on the left side of the bike, just below the seat. This will allow y…

How to change the engine oil of a Yamaha MT-07?

To change the engine oil of a Yamaha MT-07, follow these steps. Start by placing the bike on a flat surface and ensure the engine is warm but not too hot. Remove the oil cap from the top of the engine and unscrew the oil drain plug on the engine casing, usually located on the underside of the engine. Position a collection container under the drain plug and unscrew the plug to completely drain the used oil. Once drained, refit the drain plug. Remove and replace the oil filter using an oil filter spanner. Apply a little new oil to the seal of the new filter before installation. Fill the engine with new oil through the oil opening until reaching the recommended level. Check the oil level using the dipstick and add oil if necessary. Refit the oil cap and ensure it is securely tightened. Start the engine and let it run for a few minutes to distribute the oil, and you will have completed the procedure.

Watch the video!


by ScegliAuto

More videos