Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Motorcycles
    2. :
  2. Yamaha
    3. :
  3. Xmax 300
    4. : How do you deactivate the traction control of the Yamaha Xmax 300?

Model: Yamaha Xmax 300
Part: Checks and maintenance
How do you deactivate the traction control of the Yamaha Xmax 300?

To deactivate the traction control of the Yamaha Xmax 300, you need to turn on the instrument panel by turning the key in the ignition block. Once the panel is on, you can press and hold the button located on the right side of the steering wheel. While holding it down, you will notice the TCS light switch from ON to OFF, indicating that the traction control is deactivated. To reactivate it, simply press and hold the button again until the light switches back to ON.


Posted on 25 March 2024 by ScegliAuto

How to change the engine oil of a Yamaha TW 200?

To change the engine oil of a Yamaha TW 200, follow these steps. Make sure the engine is warm. Place the motorcycle on a flat surface. Remove the oil drain plug on the bottom side of the engine. Place a container under the plug to collect the used oil. Allow the used oil to drain completely. Once drained, reinsert the drain plug and tighten it securely. Remove the oil fill cap from the top of the engine. Using a funnel, slowly pour new oil into the oil reservoir, checking the recommended quantity in the owner's manual. After adding the oil, reinsert and tighten the fill cap securely. Start the engine and let it run for a few minutes. Check the oil level and add if necessary. Finally, clean up any spills and dispose of the used oil properly.

Watch the video!


by ScegliAuto

More videos