Do it yourself
Frequently asked questions about cars and motorcycles
Car tutorial (Do it yourself) Motorcycle tutorial (Do it yourself) Frequently Asked Questions

Model: Yamaha Ybr 125
Part: Engine oil

To change the motor oil of a Yamaha YBR 125, start by placing the motorcycle on a flat surface and make sure the engine is cold. Remove the oil filler cap located on the right side of the engine. Place a container to collect the used oil under the oil drain plug, which is located on the bottom of the engine. Unscrew the oil drain plug and let the used oil completely drain into the container. Once the oil is fully drained, replace the oil drain plug and tighten it securely. Now pour the new motor oil through the filler hole using a funnel. Make sure to use the recommended oil for your Yamaha YBR 125 and consult the owner's manual for the correct capacity. After adding the new oil, replace the filler cap and tighten it securely. Make sure everything is clean and there are no oil leaks. Finally, start the engine and let it run for a few minutes, then turn it off and check the oil level with the dipstick. Add oil if necessary to bring the level to the correct point. Once this procedure is completed, you have successfully changed the motor oil of your Yamaha YBR 125.

Posted on 22 May 2024 by ScegliAuto

Video tutorial

Related tutorials

How to Change the Engine Oil on a Yamaha YBR 125
How to Change the Engine Oil on a Yamaha YBR 125
Ybr 125 Let’s discover the guide that will allow you to carry out the routine maintenance service by changing the engine oil on the Yamaha YBR 125 motorcycle…
How to Dismantle the Rear Wheel of a Yamaha YBR 125
How to Dismantle the Rear Wheel of a Yamaha YBR 125
Ybr 125 Below are the instructions that will allow you to dismantle and remove the rear wheel of the Yamaha YBR 125. First, place the bike on a stand and sta…
How to Replace the Brake Light Bulb on a Yamaha YBR 125?
How to Replace the Brake Light Bulb on a Yamaha YBR 125?
Ybr 125 Replacing the brake light bulb on the Yamaha YBR 125, as shown in this tutorial, is an extremely simple and quick task. Before proceeding, ensure tha…

How to Replace the Coolant in the Piaggio Medley 125?

To replace the coolant in the Piaggio Medley 125, loosen the screws securing the side grille of the scooter to remove it and access the radiator underneath. At the base of the radiator, locate the drain plug, which must be unscrewed to allow the coolant to flow into a suitably positioned container. Next, open the under-seat compartment and locate the coolant refill cap: by opening this cap, you can insert the new coolant.

Watch the video!


by ScegliAuto

More videos