Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Alfa Romeo
    3. :
  3. 156
    4. : Rear bumper

Alfa Romeo 156 - Rear bumper

Alfa Romeo 156 (1997-2007 / MK 1)
How to remove the rear bumper of the Alfa 156
The disassembly of the rear bumper of the Alfa Romeo 156 is quite simple to carry out and you start by opening the rear bonnet to exceed the first fixing …read all…
Posted on 27 September 2023 by ScegliAuto
Airbags (1) Loudspeaker (1) Shock absorbers (1) Car stereo (5) Air Vents (1) Spark plugs (1) Glow plugs (2) Bodywork (2) Key (1) Timing belt (7) V-belt (1) -board computer (1) Checks and maintenance (5) Dashboard (4) Bearing (1) Air filter (1) Cabin air filter (6) Diesel filter (1) Clutch (3) Injectors (1) Light bulb (2) Headlight bulb (4) Rear light bulb (1) Interior lights ceiling light bulb (1) Antifreeze liquid (1) Dashboard light (4) Third brake light (1) Gear oil (3) Door panel (6) Front bumper (5) Rear bumper (1) Brake pads (6) Hydraulic pistons (1) Gear Shift Knob (3) Pump (2) Fuel pump (3) Radiator (2) Passenger compartment heating radiator (1) Fuse box (3) Seat (5) Drive shaft (1) Lambda sensor (2) Outside rearview mirror (3) Manufacturer's coat of arms (2) Thermostat (1) Turbine (2) EGR valve (1) Interior blower (1) Side window (1) Steering wheel (2)

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos