Do it yourself
Frequently asked questions about cars and motorcycles
Car Tutorial (Do it yourself) Motorcycle Tutorial (Do it yourself) Frequently Asked Questions
  1. Car
    2. :
  2. Alfa Romeo
    3. :
  3. Mito
    4. : Replacement of the timing belt of the Alfa Romeo Mito 1.4 T-Jet

Alfa Romeo Mito - Video tutorial

Model: Alfa Romeo Mito MK 1 - Years 2008-2018
Part: Timing belt
Operation: Replacement of the timing belt of the Alfa Romeo Mito 1.4 T-Jet

Let's find out in this guide the instructions that will allow us to remove and replace the timing belt of the Alfa Romeo Mito, with 1.4 T-Jet engine. First we open the engine hood and start by removing the front engine support, unscrewing the screws and lifting the engine from below with a jack; after which we also disassemble the distribution cover, unscrewing the screws, as shown in the video. At this point we disconnect the service belt and remove the turbine sleeve; unscrew the screw of the crankshaft pulley and replace the timing belt!


Posted on 18 April 2024 by ScegliAuto

    Frequently Asked Questions

    • Mito 2008-2018 - When to replace the timing belt in the Alfa Romeo MiTo? Read Answer
    • Mito 2008-2018 - After how many km is it necessary to replace the timing belt of an Alfa Romeo Mito? Read Answer
    • Mito 2008-2018 - How often does the Alfa Romeo Mito timing belt need to be replaced? Read Answer

Handbrake adjustment on Ford Ecosport

First remove the plastic profile at the base of the gear lever. To do this, slightly widen the side edges and carefully lift it to release it. There is no need to remove it completely, just move it forward to avoid bother. Now remove the plastic center console around the handbrake by first working from the rear to release it and lifting it until the brake lever passes. Also in this case it is not necessary to remove it completely but, paying attention to the connected cables, it can be stowed in front of the passenger seat. At this point we notice that at the base of the handbrake lever, on the front, we find a nut. By acting on it, with a 10 wrench, we can adjust the brake force, increasing it by turning the nut clockwise, or decreasing it by turning it counterclockwise. Once adjusted, the center console can be repositioned first, pressing lightly to engage it, and then the profile of the gearbox base.

Watch the video!


by ScegliAuto

More videos